Spinning and Swatching like a demon

 What I really want  is a "gardening gansey". Something like a "rugby jersey" but in finely knit wool.  The fabric should be like sock fabric - elastic, durable, and able to handle moisture - cotton rugby jerseys fail at the moisture control criteria.

My old ganseys are really too warm for the current climate and resulting garden chores. (We no longer own an apple orchard in Northern Pennsylvania.) One gansey was knit to the criteria of defending me from thorns as I pruned roses in the winter rains.  In these dryer times we gave up roses. 

Anyway, in experimental spinning for weaving, I spun bins of yarn in the ~ 7 thousand ypp range. Some white, some blue. Swatching tells me that those singles as 3-ply yarn (~2,000 ypp)  make a nice sock yarn, which when knit on 1.5 mm needles make nice fabric, that I think would be good for walking socks or a gardening gansey.  In the past, I knit "boot socks" from 5-ply gansey yarn (1,000 ypp). I did not really think about finer sock fabrics - I was focused on the issue of "How warm can knit wool be?"

This is a major change in paradigm. As I get older, I am less likely to go up into the snowy Sierras and more likely to just walk up Mt. Brionies - a pleasant 2-hour walk if I take the short cut.   It is past time to recognize that there is less snow in the Sierras.  On the other hand, wool boot socks do still feel good on the cold tile kitchen floor on a winter's morning, when I come down to make breakfast. I have 75 pair of good wool boot socks - enough to keep my feet warm while I cook thousands of pots of steel cut oats. 

No, that 3-ply yarn will not be a durable as 4-ply from 11,200 ypp singles. However, that 3-ply  yarn by virtue of its coarser fiber will be more durable than commercial yarns such as  Special Blauban or BeeHive.  And I have those singles on hand and I can ply enough yarn for a gansey in a morning. (I knit swatches from the 4 samples the yarn I already made.)  I will not be off at sea - if a part of the gansey gets worn, I can reknit it.  I have more of those fibers, I can always spin more yarn to match.  And, a fabric knit from 2,000 ypp yarn is just right for Mt. Brionies in any season.

To get here, I had to stop thinking in terms of  modern patterns that use commercially available yarns.

I had to swatch until I found a combination of  yarn and needles that produced a fabric that was well suited to the intended purpose. I had to revert to Knitting in the Old Way as in the book by Priscilla Gibson-Roberts and Deborah Robson. (I do not sell anything these days, but I am honest about what works for me.) Knitting in the Old Way was the key that unlocked Gladys Thompson for me.  I think, the process of swatching yarn as spun and the processes in Knitting in the Old Way produce good sweaters. 

Mostly, ganseys are knit to fit. This makes them warmer for their weight, and it means less knitting - faster production.  Knit to fit, these firm fabrics need pattern stitches to provide extra ease for movement. Sure, you can just run vertical ribs from top to bottom, but that is more work, makes a heavier garment, and not as warm as panels of plain knitting. The Sheringham ganseys have moss and chevron patterns across the chest for extra ease. I also like some of the chest patterns in Mary Wright's, Cornish Guernseys & Knit-frocks. Many of Cornish patterns are similar to the Yorkshire patterns in Gladys Thompson. I expect they were knit for men doing the same kind of jobs in the same climates. 

I have said it before,  "A sweater is only a sweater, but a sweater with matching gloves, socks, hat and muffler is an outfit."  And, gloves, socks, hats and mufflers make very good swatches.  I tend to use Mary Thomas's Knitting Book as guidance on these objects, particularly gloves. Except for gloves, I tend to knit on longer needles.   For glove fingers, I often use shorter "sock needles".  There was a time when I had special very short glove needles, but now I knit everything with a knitting sheath, and all needles are at least 5" long, and mostly steel.  If I must knit soft gloves on big needles (e.g., US2) I use 6" wooden needles because they lighter, less slippery, and less likely to fall out when held by only a few stitches on one side of a finger. 

Like a good little demon, I did recently knit Froehlich Wolle Blauband and Paton's Beehive on the recommended US2 needles. I still hate that fabric. 3-ply,  2,100 ypp yarn knit on US2, is enough firmer to make a reasonable glove fabric - better than those damned, old worthless knit  Army mitten liners!

It is time for me to transition from spinning and knitting objects that prove how warm knit wool can be to spinning and knitting objects better suited to the modern climate. Yes, the finer 20s (11,200 ypp singles) are 40% slower to spin than the warmer 10s, (5,600 ypp singles) but I can still spin them at over 300 yards per hour.  I can still spin/ply a hank (500 yards) of 4-ply sock yarn in a day. 

There is a couple hundred pounds of fiber stash in the house, ranging from Lincoln to Rambouillet, with a lot of Cotswold and Romney in between. At some point, I have spun hanks from each of those bins as 20s, 30s, & 40s. I have spun 40s (22,400 ypp) from the Romney. There is a bunch of  Heinz 57 from the Woolery, and I have spun 54s (30,240 ypp) from that  (sorry, it is not a 57s grade fiber) and there is the Rambouillet from Anna Harvey (https://www.annagotwool.com/) from which I have spun hanks of 560 yards that weighed less than 6 grams e.g., ~ 45,000 ypp). (A small part of a large fleece. Other sections of the fleece spun at closer to 40,000 ypp.)  The real lesson of that evolution was that hanks of fine singles must be tied very carefully, or they will tangle. Alden never worked with such fine threads, so his advice on tying skeins of fine singles is - understated. Some of those skeins tangled, and I called them, "My little shits". From that, many spinners assumed that I could not spin fine. No, I could spin fine, but I had a learning curve on tying hanks of 45,000 ypp singles so they could be handled.

The fiber you have on hand can likely be spun in to 22,400 ypp singles or any lower grist. Finer fibers like Shetland can be spun into 30,000 ypp singles. Merino and Rambouillet can be spun into 40,000 ypp singles.  Mostly, the fiber is not the problem.  Any fiber you buy in a retail store selling spinning supplies can be spun into 22,400 ypp singles.

I think all the books on spinning for knitting, fail to properly discuss plying. Alden fails to talk about using a tension box to facilitate plying.  Great knitting yarns are spun rather fine, then plied to a useful grist. A tension box is essential for smooth, easy, consistent plying.  With a tension box, 5-ply or 10-ply yarns are  easy. Without a tension box, consistent plying is difficult.   With thicker singles (10s) I can ply from center-pull cakes. For sock yarn with finer singles, I ply from bobbins. I think all plied yarns need to be steam blocked.  Steam blocking results in a much better yarn (knitting or weaving). 

And when I buy commercial combed top or roving, I steam it prior to combing. Yes, I comb, diz, and plank and diz commercial combed top. The top is wound into birds nests, then carefully transferred to the distaff for spinning. Fiber that sits as bird nests for a few weeks gets recombed.  And, that is some how I spin finer than most hand spinners.